Access the Material Deposition Module
The Material Deposition Module can only be used after the task has been programmed.
The user can access the material deposition module in the Device Mode at the Setup Settings level as Figure 1 shows.
Figure 1: Setup settings, Material deposition
Then, the user has to enable the module and select the settings as Figure 2 shows.
Figure 2: Material deposition settings.
Once the Material Deposition module has been enabled, these settings will be implemented to the entire Setup.
If different Material Deposition settings are required in different programs, overrides can be added at the Program Level as Figure 3 shows:
Figure 3: Material deposition Overrides for Program Settings.
Likewise, these settings can be overridden at the operation level like Figure 4 shows.
Figure 4: Material Deposition Overrides for Operation Settings.
Once the proper Material Deposition settings are selected and confirmed, the user can choose to show or hide the added material accordingly by clicking on the Additive Material Setting as shown in Figure 5.
Figure 5: Additive Material Settings.